DCWV EMBOSSED SMILE CARD TUTORIAL
SUPPLY LIST
DCWV
Two-Tone Solid Cardstock
Tim
Holtz Distress Ink in Dried Marigold, Ripe Persimmon and Seedless Preserves
Ink
Blender Tool
Flower
Embellishment
Chipboard
Letters
Ruler
Scissors
or Paper Cutter
Glue
or Double Sided Tape and Hot Glue
Spray
Bottle and Paper Towel
Grab
your DCWV Embossed White Stack and find this floral sheet. Using Tim Holtz
Distress Inks in Dried Marigold, Ripe Persimmon and Seedless Preserves, blend
theses colors around a 7” x 8” area.
Spritz
some water on the paper and let sit for a few seconds, then blot with a paper
towel. Repeat this again.
With your blender tool, and the same distress inks, lightly
add more color to the sheet. Make sure you do this lightly so the color only
transfers to the raised design on the paper. This will give a little more
definition and make the print more visible.
Set this aside to dry.
Find a solid color cardstock that coordinates with your
inks. I chose a 2 tone cardstock from DCWV. The other side of this paper is a
different shade.
Cut a 7” x 10” piece, and fold it in half.
On
the front of the card, measure in 1/8” on the 3 sides. Using scissors or a
paper cutter, cut off those 1/8” strips.
If
done correctly, once you fold the card, you will see the second color shade
from the other side of the paper. This will give a border effect to the card.
Cut a piece from your embossed floral sheet. The dimensions
will vary, depending on the cut of your card base. I measured my piece so it
will be constantly 1/8” smaller on all sides.
Secure this piece to the card using glue or
double sided tape.
Grab some chipboard letters. I had these darling DCWV Polka
Dot letters in my craft stash, but they were silver in color. I wanted them
gold, so I grabbed my metallic gold spray paint and sprayed them. If you paint
your chipboard, make sure they are completely dry before handling them.
Once you are ready, secure them to the card,
centered horizontally. I used a ruler to make sure I applied them straight.
Since the embossed paper I used was a floral print, I wanted
to add some flowers to the card.
I dabbed this white flower on the distress ink
pads to get a little coordinating color on them. I then hot glued them to the
bottom right corner of the card.
Now
you have your finished card!